1977 Bayfield 32

The Bayfield 32 has a classic interior with a V-Berth forward with storage below. The head is immediately aft and has hot and cold running water and a marine toilet with a holding tank.

The salon has a large C-shaped dinette to starboard that converts into a large double berth. On the port side is a full-length settee.

Aft of the salon is the galley to starboard with deep sinks, propane stove, and oven as well as refrigerator unit. To port is a navigation station and a quarter berth aft under the cockpit.

The interior upholstery has been updated and all the wood has been re-finished including new teak and holly flooring. It looks great inside.

• Newer upholstery and cushions

• New teak and holly laminate sole

• ESPAR forced air heater

• Caribbean Dickinson 2-burner propane stove with oven

• Stainless steel sink

• Pressurized fresh water with 40-gallon tank

• Enclosed head with toilet (15-gallon holding tank)

• Pressure sink & shower

• Newer dinette folding table

• Force 10 BBQ

Has the basics for cruising the coast and almost everything is less than 5 years old.

• EVO 100 Raymarine autopilot with self-calibrating rate compass

• Hawkeye depth sounder

• Lowrance VHF Radio with DSC

• CP175c Standard Horizon plotter with charts for the Pacific Coast, Mexico, and the Caribbean.

• 2 X 100-watt solar panels and 10 amp charge controller.

• ProMariner Pro Sport 12 battery charger

• LED lighting

• 1500 watt Eliminator inverter

• 2 X 12 Volt HD Series 27 House Batteries

• 1 X 12 Volt HD Battery 24 Starter Battery

Can be run as a cutter or sloop-rigged boat with roller furling on the foresail. New sails were made in 2018 with limited use. Standing rigging was upgraded in 2015 and was inspected and re-tuned in 2023. The mainsheet traveler has been moved on top of the aluminum dodger to free up room in the cockpit. All lines are led aft making this a fantastic boat for single handing.

• Oversized standing rigging was upgraded in 2015.

• Sail pack from Leach McBride 2018

• Leitch & McBride Full battened main and genoa 2018

• Asymmetric spinnaker, storm sail, and spare genoa.

• Rocna 15 anchor

• Lewmar Pro 1000 anchor windlass (with cockpit and deck switches)

• 100 feet of 5/16 chain with 200 feet of ½” nylon rode

• Stainless steel bow roller

• Spare new Danforth 25 lb and nylon rode.

The engine was rebuilt and has 850 hrs since the rebuild. It also went through a full assessment at Stones Marina in 2023 and every recommendation was completed. This included a compression test and a new alternator was installed.

• Yanmar 3GMD 20 hp

• Kanzaki KM3-A marine gear

• PSS, dripless shaft seal

• Morse dual levers at the helm

• 16 gallon fuel tank

• A new rigid hull inflatable tender was purchased in 2023 as well as a new outboard.

• Manual pump and automatic electric bilge pumps

• Stainless folding safety ladder

• LED navigation lights

• LED spreader/deck light

  Upgrades & Maintenance since 2020

• New high-pressure oil line

• New water pump

• The exhaust system completely replaced including the stainless mixing elbow

• Fuel injectors cleaned

• New spare starter

• New teak/holly veneer marine plywood floor

• New folding table in the salon

• New teak dish/spice rack

• New teak cockpit table

• New bimini extension for dodger

• New cockpit cushions

• New hot water heater

• New curtains

• New asymmetrical spinnaker

• New storm jib

• Hull sanded down to gel coat with new barrier cote and multiple coats of Micron CSC